Tips to Using a Rifle Scope for Best Shooting

Tips to Using a Rifle Scope for Best Shooting

A riflescope greatly helps in hitting the target- if there is sufficient knowledge about proper use of riflescopes. The quality of a riflescope is a major contributing factor to how well target shooting turns out to be. Aside from that, proper use is the next most important factor, about this click site: Here are 6 tips to proper use of riflescope for great shooting.

Mounting the riflescope

For traditional rifles, the riflescope has a power of around 1.5x to 50x. The riflescope is bore-sighted from the shooter once it is adjusted. If choosing to mount the riflescope right on top of the rifle, calibrated the range and make sure it is at zero. This setting means that at a certain distance, the bullet will land very close to where the rifle is pointed at. That is, without factoring in elevation and wind speed. Commonly, standard combat rifles are zeroed at 100 yards.

Deciding how far from the target the shot lands

Modify the riflescope according to the shooter’s position and the position of the target. Factor in the wind and elevation. Most riflescopes are already equipped with dials for elevation and wind age, which are adjusted to compensate for inaccuracies related to these 2 factors. Adjusting for elevation is done by adjusting the upper dial. This will adjust the POI (point of impact) of the bullet upright. Adjustments for windage are usually with the dial on the right of the scope.  This moves the bullet POI straight.


This is also the Ballistic Plex reticle. This allows for more ease with shooting at targets farther than the riflescope’s zeroed scope. Adjustments for this are based on a diagram that shows the bullet speed, heaviness and caliber.

Tuning windage and elevation

Fine-tune the elevation and windage for more accuracy. Re-zeroing is not necessary. Just make a rough calculation of the effects of factors like wind and elevation and then make the necessary adjustments.

Adjusting parallax

Adjustments in the parallax are based on the target’s distance. The parallax tends to shift slightly based on the eye relief of the shooter and the distance of the target. To prevent the shift, which can affect accuracy, the shooter places his head in relief position, making sure that he can still see the black area around the corner as he looks down on the scope. To balance the black area around all the corners of the reticle, move the head and the eye. For fixed parallax scopes, the reticle is normally at a 150-yard setting. For 500 yards, the maximum is 1 ½ inch off the ground. For 100 yards, the reticle is off the ground for 8 inches.

Positioning the cross hairs

The cross hairs should be at the center of the target at a 0 distance while making the necessary adjustments in the riflescope. Compensation for distance may be required, as well as for any breeze, and the shooter’s and target’s positions. Hover or drop the cross hairs to keep them centered on the target.


Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>